- På salg!
Luftfjæring Kompressor Audi A6 C7 4G WABCO 4154039692
Genuine Wabco Air Suspension Unit - Made in Germany
New replacement air compressor from Wabco, the original equipment supplier to audi. Unlike compressors that are simply modified to fit the vehicle, this compressor was designed by Wabco specifically for the 2012-2018 audi C7 chassis (Typ 4G) A6 Avant, Allroad Quattro and S6 incorporating high level integration mechatronics. This high-performance, yet quiet, Wabco compressor includes a maintenance-free integrated air dryer and comes completely assembled from the Wabco factory in Germany with an application specific air line, wiring harness and brackets. This direct replacement compressor comes in a Wabco box and is ready to install with included application-specific mounting hardware.
CAUTION: The replacement of the relay 4H0951253 (not included) is mandatory, otherwise the warranty on the compressor is forfeited!
- Genuine OES Compressor from Wabco
- Includes Air Hose
- Pre-Assembled For Easy Installation
4G0 616 005 D; 4G0616005D
4G0 616 005 C; 4G0616005C
415 403 418 0; 4154034180
415 403 969 2; 4154036962
2010-2018 audi A6, Allroad, Sedan, Avant quattro (C7)
Before you buy a compressor please keep in mind that the main reason a compressor fails is because there is a leak in the Air Suspension System causing the compressor to overwork and burnout. The most common cause for a leak in the system is an old leaky air spring bag. Your compressor warranty will be voided if air spring bags have not been recently replaced in your vehicle. We recommend that in order to maintain your Air Suspension System in optimal condition you purchase new air spring bags.
Our technical advise for the air supply device:
1. Increased noises while the compressor is running may be caused by a non-functioning compressor mounting.
Change the rubbers and springs of the mounting in any case.
2. A porous intake hose often is the cause for a breakdown of the compressor.
Change the intake hose and preferably also the filter and noise absorber, because we do not want the compressor to breakdown because of these.
3. Change the relays before installing the compressor even if it seems to still work.
This is also a specification by the car manufacturer. Be sure to change the right relays.
Relays look similar, that is why there is a risk to change the wrong relays.
4. Be sure to check whether the system is leakproof after repairing.
The easiest way to do this is to park the vehicle. Wait for the system to automatically re-adjust if your car has this feature.
Then measure the heights from the ground to the lower edge of the fender as exactly as possible and take notes.
On the day after measure these heights again and compare them with the ones before. Even a small difference will lead to a damaged compressor and damaged valves in the long run.
When driving with a leaking suspension for a long time it needs to be assumed that the compressor is running more often than normal. The increased number of cycles of powering on and off is likely to already have damaged the compressor. Depending on the duration of that condition you should change the relays and check the performance of the compressor to be on the safe side. After the vehicle stood overnight the compressor normally doesn't need to run more than 20 to 30 seconds for the system to be ready to start.